Advertisement
Setting the Clock
Seffing the Clock
The Q
pad is used to set the clock. The clock may be set for 12 or 24 hour time of day operation. The clock has been preset
at the factory
for the 12 hour operation. When the range is first plugged
in_ or when the power supply to the range has been
interrupted_ the timer in the display
will flash.
Press _.
The display
will stop flashing.
iNSTRUCTiONS
PRESS
DISPLAY
To set the clock (example
below
for 1:30)
1.
Press
Q.
"CLO"
wiJJ appear
in the
display
(Fig. 1).
(_
2.
Press
1 3 0
pads to set the time of day to 1:30 (Fig. 2). Press _.
] 3 0
The time of
day
will appear in the display (Fig. 3).
Changing
between
12 or 24 hour
time
of day display
1.
Press and hold Q
for 7 seconds until "|2Hr" or "24Hr" appears
in
the display.
2.
Press Flex
Cleon to switch between the 12 and 24 hour time of day display.
The display
will show either "|2Hr" (Fig. 4) or "24Hr"
(Fig. 5).
3.
Press _T_ to accept
the change
or press _
to reject the change.
4.
Reset the correct time as described
in To set the Clock above. Please
note that if the 24 hour time of day mode was chosen° the clock wiii
now display time from 0:00 through
23:59 hours.
Q
for 7 seconds
Flex
Clean
Q
or press 0
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
16
Advertisement
