Advertisement
Setting Surface Controls (co.t,d)
Operating
the Triple Surface Element
The cooktop
is equipped
with a Triple radiant
surface element
located
at the right front cooktop
position
(Figure 1). Indicator
lights on the control
panel at that position
are used to indicate
what portions
of the Triple radiant
element will heat. The 0
light indicates that only the inner element
will heat. The @
light indicates that both inner and middle
elements will heat
The @
light indicates that all 3 portions
of the
together.
element
will heat. You may switch between
all of these different
settings at any time during
cooking.
To Operate
the Trlple
Surface
Element:
1.
Place correctly
sized cookware
on the radiant
surface
element.
2.
Touch and hold the _O_j)Fpad for the Triple element
position
until a beep is heard. The display
will show " - - "
.
4.
5.
Note:
If no further
pods are touched
within 10 seconds the
request to power the element
ON will clear.
Select theO (See Figure
(See Figure 3 )or@ elements (See Figure
4) to heat by pressing the _
pad once, twice
or three times (Figures 4
show indicator
lights with ALL 3 elements
selected).
Touch Hi pad once to turn ON the power level to HI (See Figure 5). Touch Lo
pad once for Lo.
Each touch of the Hi or Lo pad will decrease
or increase the power level
from 9.0 through
3.0 by .5 increments.
Simmer power levels between
3.0 and
1.2 will decrease
or increase
by .2 increments.
Lo is the lowest power level
available.
Note: The power level may be adjusted
at any time while the element
is ON.
Figure 1
Figure 2
Each surface
element
provides
a constant
amount of heat at each setting.
Irregular
glowing
effect
is depending
of the element design and doesn't
affect
performance
of the element. A glowing
red surface heating
area
extending
beyond the bottom
edge of the cookware
indicates
the cookware
is too small for the surface
heating
area.
6.
When cooking
has been completed
touch the _
pad once to turn the
element
OFF.
Note:
If no element
size is chosen when the Triple element
is turned ON, the
control will default
to the inner coil only. See recommended
surface cooking
settings.
Note: The Hot Surfoce message will be displayed
on the control
panel as soon as
the element
is hot and will remain ON until the heating
surface
area has cooled
sufficiently.
Figure 3
F
4
@
Hot Surface
OOO
O
@
Figure5
Radiant surface
elements may appear
to have cooled
after they have been turned off. The gloss surface may
still be hot and burns may occur if the glass surface
is touched
before it has cooled
sufficiently.
Do not place aluminum
toll or plastic items such as soil and pepper shokers, spoon holders or plastic wroppings
on fop of the range when
if is in use. These items could melt or ignite. Pothoiders,
towels or wooden
spoons could catch fire if
placed
too close to the surface elements.
11
Advertisement
