Kenmore 79097602301 Installation Instructions Manual

iNSTALLATiON AND SERVICEMUST BEPERFORMED BY A QUALifiED iNSTALLER.
iMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.
F_ FOR YOUR SAFETY: Do not store or
use
gasoline or other
Nammable vapors and liquids in the vicinity of this or any other appliance.
. Clearances and Dimensions
a. Provide adequate clearances between the range and adjacent combustible surfaces.
b. Location--Check location where the range will be installed. Check for proper electrical supply and the stability of floor.
c. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface
must be solid and level.
United States
SIDE =
i
i
Maximum d epth _
for cabinets [;
LS_ 25,
O"clearance below cooking top and at rear of range.
30" minimum clearance between the top of the cooking surface
and the bottom of an unprotected wood or metal cabinet; or 24
" minimum when bottom of wood or metal cabinet is protected
by not tess than 1/4" flame retardant millboard covered with not
less than no. 28 MSG sheet steel, 0.015" stainless steel, 0.024"
aluminum or 0.020" copper. The minimum clearance is 0" for the
rear of the range. Follow all dimension requirements provided
above to prevent property damage, potential fire hazard, and
incorrect countertop and cabinet cuts.
Avoid locating cabinet storage space above the surface units to
eliminate the possibility of cabinets catching on fire, or personal
burns from reaching for the cabinets over the heated units. If
cabinet storage is to be provided, risk can be reduced by installing
a range hood that projects horlzontally a minimum of 5" beyond
the bottom of the cabinets.
Important Notes to the Installer
1. Read all instructions contained in these installation
instructions before installing the appliance.
2. Remove all packing material before connecting the electrical
supply to the appliance.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consumer.
BACK
VIEW
All dimensions for
electrical outlet location ore
....... . maximum.
Cubed area shows
Term_ncd " where the electrical
Block _ outlet must be installed
Location _ i for the range to be
_qL _'_-_,_ flush to the wall.
Important Note to the Consumer
Keep these instructions with your Use and
Care Guide for future reference.
Printed in Canada 318201736 (1201) Rev. A