Table of Contents
Advertisement
Reinstalling the RealiZm II Video Display Driver
Follow these instructions if you need to reinstall the RealiZm II video display driver.
To reinstall the RealiZm II video display driver:
1.
Turn on system power and log on to the Windows NT operating system.
2.
From the Start menu, go to Settings/Control Panel/Display/Settings.
3.
In the Settings tab, click Display Type.
4.
In the Display Type dialog, click Change.
5.
In the Change Display dialog, click Have Disk.
6.
Insert the diskette containing the RealiZm II video display driver into the system's floppy
disk drive; then click OK.
7.
At Change Display, click OK.
8.
At the third-party driver warning, click Yes.
9.
At the Installing Driver dialog, click OK.
10. At the Display Type dialog, click Close.
11. If desired, configure the video display according to the system configuration and your
preferences. Refer to your system documentation, or select a setting and press
more information.
12. Click Apply at the bottom of the dialog to apply the changes.
13. Remove the diskette from the system's floppy disk drive.
14. Restart the system.
Troubleshooting the Installation
If you suspect a hardware problem, use the following troubleshooting procedures to help
determine which hardware assembly to return for repair.
Diagnostics
Diagnostic utilities for checking the RealiZm II and Geometry Accelerator cards and
instructions for using them are available on the World Wide Web or from the Intergraph
Bulletin Board Service (IBBS). Refer to the Preface of this document for more information.
13
, for
F1
Advertisement
Table of Contents
Need help?
Do you have a question about the RealiZm II Graphics and is the answer not in the manual?
Questions and answers