Configuring Realizm Ii Video Display Properties - Intergraph RealiZm II Graphics Hardware User's Manual

4
3. When prompted, press
4. Log on to Windows NT. Refer to Windows NT documentation and Help for instructions,
if necessary.

Configuring RealiZm II Video Display Properties

To enable your workstation to use its RealiZm II card, you must configure the display
properties of the RealiZm II video display driver. The RealiZm II video display driver is
installed on the system's primary hard disk drive. The Display Properties dialog is available
from the Control Panel to determine the system configuration and installed options. Display
Properties lets you change the video display settings to meet your needs.
To configure RealiZm II video display properties:
1. From the Start menu, go to Settings/Control Panel/Display.
2. When the Notice dialog displays, click OK.
3. On the Display Properties dialog, click Intergraph Monitor (tab).
When a supported video display driver is running on your system, the Intergraph Monitor
tab displays text describing the graphics hardware and monitor present on your system.
The tab allows you to review and change the settings of your system's video attributes,
such as monitor type.
NOTE If this is your first time to install the video display driver (for example, when reinstalling
Windows NT), the Intergraph Monitor tab does not display until you restart the system.
4. Select and change the supported settings as desired. Refer to Help for information about
each setting. Context-sensitive help is available by selecting a setting and pressing
5. Click Color Calibration to change the gamma correction for your monitor, if desired. The
Color Calibration dialog displays.
The appearance of the Color Calibration dialog varies, depending on your graphics
hardware and selected video display settings. If your system is configured with multiple
screens, for example, you can use the pull-down menu to select which screen to modify.
NOTE The Color Calibration dialog is available only when the driver is running.
6. Click OK to close the Color Calibration dialog, or click Cancel to close Color Calibration
without applying the changes.
7. Click OK to close the Display Properties dialog, or click Cancel to close Display
Properties without applying the changes.
8. If you have changed video attribute settings other than gamma correction, restart the
system for the changes to take effect.
+ + to log on to Windows NT.
CTRL ALT DEL
.
F1