Spirit XT485 Owner's Manual page 6

STEP 1: Upright T ubes
1. Install the four speed nuts (128) onto the tabs of the frame.
Take the Left and Right upright tubes (part numbers 5 & 4) and slip the upright covers (67 & 61 left, 66 & 62
2.
right) onto the tubes (observe the cover orientation is correct). Connect the Middle Console Cable (50) that
exits from the bottom of the right console mast tube with the lower Console Cable (49).
NOTE: Partially tighten all bolts in this step. This will allow for easier console assembly.
3. Insert Right and Left Uprights (4) and (5) into the Frame Base (2) and attach with eight Button Head Socket
Bolts (130) using the Allen wrench/screwdriver (131). Attach two more Button Head Socket Bolts (130) and
two Flat Washers (147) on the inside surface of the upright tubes.
Be careful not to pinch the wire when installing the upright.
HARDWARE
#130. 5/16" x 15mm #147. 5/16" x 18 x 1.5T
Button Head Socket Flat Washer
Bolt (10 pcs) (2 pcs)
6
XT485
T readmill
#128. M5 Speed Nut
Clip (4 pcs)
7
XT485
T readmill