Brother 882-W04 Operation Manual page 273

e
When the following message appears, press
.
→ The pattern will be returned to its original size,
angle, and position as it was before it was edited.
f
Select how to change the pattern size.
* Press to enlarge the pattern proportionately.
* Press to shrink the pattern proportionately.
* Press to stretch the pattern horizontally.
* Press to compact the pattern horizontally.
* Press to stretch the pattern vertically.
* Press to compact the pattern vertically.
* Press to return the pattern to its original
appearance.
Memo
• With the density scale bar, the thread den-
sity can be changed.
A setting between 80% and 120% in 5%
increments can be specified.
* Press to make the pattern less dense.
* Press to make the pattern more dense.
g
Press .
h
Press .
Note
• Depending on the pattern, embroidering
may not be possible at the appropriate
thread density. Before sewing on your
project, be sure to sew trial embroidery on a
piece of scrap fabric that is the same as the
fabric used in the project using the same
needle and embroidery thread.
• If the pattern is enlarged and there is space
between stitches, a better effect can be
achieved by increasing the thread density.
• If the pattern is reduced and the stitching is
too thick, a better effect can be achieved by
reducing the thread density.
CAUTION
• Depending on the pattern, the stitching may
become entangled or the needle may break
when the pattern is reduced. If this occurs,
enlarge the pattern slightly.
EDITING PATTERNS
6
271