Appliqué; Appliqué Sharp Curves; Appliqué Corners - Brother 882-W04 Operation Manual

Appliqué
a
Use a temporary spray adhesive, fabric glue
or a basting stitch to attach the appliqué to
the fabric.
* This will keep the fabric from moving during
sewing.
a Appliqué
b Fabric glue
b
Select or
* Adjust the stitch length and width to correspond to
the appliqué shape, size, and quality of material (see
page 78).
Memo
• For details on each stitch, refer to the
"STITCH SETTING CHART" at the end of
this manual.
c
Attach presser foot "J". Check that the
needle drops slightly off the edge of the
appliqué, then start sewing.
a Appliqué material
a Needle drop position
.
■ Appliqué Sharp Curves
Stop the machine with the needle in the fabric
outside the appliqué. Raise the presser foot and turn
the fabric a little bit at a time while sewing for an
attractive finish to the seam.
■ Appliqué Corners
Stop the machine with the needle in the right
position of the outside (or inside) corner of the
appliqué. Raise the presser foot and pivot the fabric
to align the fabric edge. Lower the presser foot and
continue stitching.
a Outside corner
b Inside corner
Memo
• Placing a lightweight tear away stabilizer
beneath the stitching area will improve the
stitch placement along the edge of the appli-
qué fabric.
SEWING THE STITCHES
3
125