Adjustments During The Embroidery Process; If The Bobbin Runs Out Of Thread - Brother 882-W04 Operation Manual

Embroidery and sewing machine
Table of Contents

Advertisement

ADJUSTMENTS DURING THE EMBROIDERY PROCESS

Note
• Be careful not to bump the embroidery unit carriage or the presser foot when removing or attaching the
embroidery frame. Otherwise, the pattern will not embroider correctly.

If the Bobbin Runs Out of Thread

When the bobbin begins to run out of thread
during embroidering, the machine will stop and
the message below will appear. Press
follow the directions below to rethread the lower
threading. If very little sewing remains, you can
embroider 10 final stitches without rethreading the
machine by pressing
after sewing the 10 stitches.
Note
• If "Upper and Bobbin Thread Sensor" in the
General settings screen of the machine
setting mode is set to "OFF", the message
shown above does not appear.
a
Press
.
→ After the thread is automatically cut, the carriage
will move.
and
. The machine will stop

ADJUSTMENTS DURING THE EMBROIDERY PROCESS

b
Unlock the frame-securing lever and
remove the embroidery frame.
*
Be careful not to apply strong force to the fabric at
this time. Otherwise, the fabric may loosen in the
frame.
c
Insert a wound bobbin into the machine.
(see page 54 for Setting the bobbin.)
d
Press
.
→ The carriage will return to its original position.
e
Attach the embroidery frame.
f
To return to the spot in the pattern where
you stopped sewing, follow steps
i
through
in the next section.
5
c
229

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

882-w05Nv6700d

Table of Contents