Using External Power Sources - Roland R-26 Owner's Manual

Using External Power
Sources
When using an external power supply, be
sure to set the final voltage.
The final voltage refers to the voltage
when voltage can no longer be supplied
because the capacity of the external power
source is reduced and voltage decreases as
electricity is consumed. If the final voltage
is not properly set for the external power
source, the remaining power display cannot
be shown. Refer to the user's manual of the
external power supply for the final voltage
value.
Furthermore, when the "Battery Low"
message is displayed, the recording
automatically stops, and the power
automatically turns off.
Change the external power source.
* When using an external power source,
even when power is automatically cut
off, the R-26 starts within 30 seconds
after power is turned back on. During
this period, the final voltage settings can
be changed.
* Read the following to set the final
voltage for the R-26.
MEMO
Refer to the user's manual for the external
power source when using an external
power source.
Setting the final voltage
1.
Choose [MENU]
2.
Touch <EXT-POWER> .
"EXT-POWER" is located on page 3/3. Touch
to access 3/3.
3.
Touch the final voltage value that you
want to specify .
Setting
Adaptor, 9.0 V, 9.5 V, 10.0 V, 10.5 V, 11.0 V, 11.5
V, 12.0 V
4.
Touch <BACK> to return to the menu
screen (p . 18) .
Getting Ready
<SYSTEM SETUP> .
Ú
23