Vehicle Profiles; Button Description - ZENEC GPS NAVIGATION SYSTEM Main User Manual

Vehicle profiles:

When you first tap
the following options:
Button
When creating a new vehicle profile, first you need to select the vehicle type. Then you need
to set the following parameters (some of them may not exist for the selected vehicle type).
You can modify the same parameters when you edit an existing profile:
Button
ZENEC device excludes unpaved roads by default: unpaved roads
can be in a bad condition and usually you cannot reach the speed limit
on them.
, you see the list of default vehicle profiles. You have
You can edit the parameters of the vehicle profile.
Tap this button to rename the profile for something meaningful.
Enter the average consumption of your vehicle when used in built-up
areas. The unit for consumption can be set in Regional Settings.
Enter the average consumption of your vehicle when used on
highways. The unit for consumption can be set in Regional Settings.
Select the engine and fuel type of your vehicle. This helps in
estimating the CO emission.
2
Enter the average fuel price for travel cost calculation. The currency
can be set in Regional Settings.
Set the maximum speed you travel with the vehicle.
Check this box to enable more settings for the below parameters.
Set the total length of the vehicle.
Set the width of the vehicle.
Set the height of the vehicle.
Set if there is a trailer attached to the vehicle.
Description
Description
71