Operation; Before You Begin; Location Of Controls - Travis Industries DVS EF Fireplace Owner's Manual

Before You Begin

• Read this entire manual before you use your new fireplace (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property damage, bodily
injury, or even death.
Location of Controls - See explanation below
Gas
Control
Valve
Gas Control Knob
Blower Knob
On/Off Switch
Pilot Igniter
Gas Control Knob
Flame Adjust Knob This knob controls the flame height from low ("LO") to high ("HI"). The pointer
© Travis Industries

Operation

Swing the control cover down
to access the gas control valve,
igniter, and blower control.
Flame Adjust Knob
This knob controls the speed of the internal convection blower that pushes
the heated air into the room.
This control is used to turn the fireplace on and off.
The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark directly next
to the pilot, igniting the pilot flame.
This knob is used to control gas to the fireplace and for starting the pilot.
There are three positions, ON, OFF, & PILOT. The pointer to the left of the
knob indicates the position this knob is in.
above the knob points to the position this knob is in.
The Pilot Flame can be found below
the back log on the left side.
ON/OFF Switch
PILOT
ON
IGNITER
OFF
Pilot Igniter
4041213
2 9
Blower Knob
1 0 0 - 0 1 1 5 2