Resetting The Receiver To Factory Default Settings; Using Troubleshooting Tools - Dish Network 311 User Manual

Chapter 3
Using the System
Page 56
R R
ESETTING THE
S
ETTINGS
Use these instructions if you want to reset the receiver to be the same as
when it was shipped.
: Resetting the receiver discards all Favorite Lists except the
Note
and lists. If you have set any locks on the receiver, and the receiver
All Sub
is locked, these locks will be kept. Only the Customer Service Center can
reset the receiver to bypass a receiver lock.
1. Press the MENU button.
2. Select the
System Setup
3. Select the
Installation
4. Select the
Factory Defaults
message, prompting you to confirm that you want to reset the receiver.
5. Select the
Yes
displays the
Installation
U T
SING ROUBLESHOOTING
Your receiver has diagnostic tools that a Customer Service Representative
may ask you to use if you should ever run into problems while using your
equipment. Even though these tools are quite helpful, it is recommended
that you only use them when on the phone with a DISH representative.
R Y R
ESETTING OUR ECEIVER
Reset your receiver as directed by the Customer Service Representative as
follows:
1. Press and hold the front panel POWER until the green indicator blinks
once and the TV screen goes blank.
2. Release the front panel POWER button. It will take a few minutes for
your receiver to reset and come back on. When you reset your receiver,
your receiver will download an updated
F
ECEIVER TO ACTORY
option.
option.
option.The receiver displays a
option to confirm the reset. The receiver resets, and then
menu.
T
OOLS
D
EFAULT
All Chan
Warning
.
Program Guide