R
C. Glass Replacement - Side Window
•
Frequency: As needed
•
By: Homeowner / Qualified service technician
•
Task: See the following instructions.
1. Open door and remove vertical brick in the bay
window area.
. Reach inside firebox and loosen hex bolts using a
/8 inch socket wrench holding the cast in place.
3. Only remove the 2 bolts, top and bottom on the side
closest to the firebox opening. Figure 30.1
4. Open the side of the window where the bolts have
been removed and slide out glass.
5. Slide new glass in making sure it slides into the cast
grooves.
6. Re-assemble in reverse order. Do not overtighten
bolts.
Slide Window In / Out
Loosen
bolts
Figure 30.1
Page 0
5100-I ACT WOOD INSERT
Remove
bolts
438-0380D
D. Door Handle Assembly Replacement
•
Frequency: As needed
•
By: Homeowner / Qualified service technician
•
Task: See the following instructions.
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install second washer(s) as shown.
. Install key in groove.
5. Align groove in latch cam with key; slide latch cam
over shaft
6. Install locknut.
. Install spring handle turning in a counter-clockwise
motion to desired location on handle.
Door Cross
Latch Cam
Section
Locknut
Spacing Washers
Figure 30.2
CAUTION
• Do NOT overtighten lock nut.
• Door handle needs to move smoothly.
Spring Handle
Door Handle
Square Key
September 1, 2008