Glass Replacement - Side Window; Trim Ring Replacement - Side Window; Snap Disc Replacement - Quadra-Fire 5100 ACC Owner's Manual

C. Glass Replacement - Side Window
(Replace with 5mm ceramic glass only)
1. Open door and remove vertical brick in the bay window
area.
2. Reach inside fi rebox and loosen 4 hex nuts using a 7/16
inch socket wrench holding the cast in place.
3. Carefully remove the cast and window together so that
the glass does not fall out.
4. Place new glass in the cast making sure it rests into the
cast grooves.
5. Re-assemble in reverse order. Do not over-tighten nuts.
Figure 23.1
D. Trim Ring Replacement - Side Window
(Replace with 5mm ceramic glass only)
1. Follow Steps 1 through 3 above.
2. Remove the trim by removing 4 nuts using an 11/32 socket
or nut driver.
3. Follow Steps 4 through 5 above.
February 25, 2016
E. Snap Disc Replacement
1. The snap disc bracket assembly is located on top of the
blower housing in the center. Figure 23.2.
2. Remove the 4 hex head bolts using a 5/32 Allen wrench
from the blower housing and pull the housing towards you.
3. Pull the snap disc and spade connectors up and out of
bracket as shown in Figure 23.3.
4. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors. Replace with new snap disc and
re-connect to spade connectors.
5. Push the snap disc and spade connectors back inside
bracket and re-attach the bracket to the appliance.
6. Re-attached the blower housing to the appliance.
Snap Disc
Figure 23.2 Snap Disc Location
Snap Disc
Figure 23.3
7047-911D
51I ACC Wood Insert
23