Configuration Information - Factory Integrated Models - HP ProLiant DL120 Quickspecs

QuickSpecs

Configuration Information - Factory Integrated Models

NOTE: This section lists some of the steps required to configure a Factory Integrated Model. To ensure only valid configurations are
ordered, HP recommends the use of an HP approved configurator. Contact your local sales representative for information on CTO
product offerings and requirements.
NOTE: HP does not allow factory integration of options into standard models listed above. Configure-to-order servers must start with
a CTO Chassis.
NOTE: FIO indicates that this option only available as a Factory Installable Option.
Step 1: Base Configuration (choose one of the following configurable models)
Models HP ProLiant DL120 G7 Pluggable 4 LFF Configure-to-order Server
Includes:
Embedded NC112i Gigabit Server Adapter (x2)
1 full length PCI Express Gen2 x16 slot (x16 connector) and 1 half length low profile PCI
Express x4 slot (x8 connector)
HP Integrated Lights-Out Standard (iLO 3)
HP Smart Array B110i SATA RAID Controller (RAID 0/1/1+0)
Rack (1U) form factor, (1.75 in/44.45 mm)
One Highline IEC Power Cord
4 Non-Hot Plug Fans
Fixed, mounting rails
HP ProLiant DL120 G7 Hot Plug 8 SFF Configure-to-order Server
NOTE: This configuration requires the HP Smart Array P410 Controller be purchased
separately to support 8SFF HDDs.
Includes:
Embedded NC112i Gigabit Server Adapter (x2)
1 full length PCI Express Gen2 x16 slot (x16 connector) and 1 half length low profile PCI
Express x4 slot (x8 connector)
HP Smart Array B110i SATA RAID Controller (RAID 0/1/1+0)
Rack (1U) form factor, (1.75 in/44.45 mm)
One Highline IEC Power Cord
4 Non-Hot Plug Fans
Fixed, mounting rails
DA - 14009 Worldwide — Version 21 — March 25, 2013
HP ProLiant DL120 Generation 7 (G7)
647339-B21
647340-B21
Page 15