Log Messages - Canon VB101 User Manual

Log Messages

The Syslog log messages are classified into the following 5 categories. Classification details are dealt with
in the UNIX syslog and the levels are explained in Chapter 3 ( P.54).
Fault Severity
Classification Level
crit Error Critical fault at the software level (stops task operation)
Fault involving a malfunction (operation interrupted)
err Error
Fault not involving malfunction
warning Warning
Fault outside the system
notice Warning
Information on correct operation
info Information
* The syslog facility is local7.
Log Messages for Applications
A002 Protocol initialization failure (err)
%1 protocol not installed
Message
protocol type <LS/C|LS/D|LS/H|VW/C|VW/D|VW/E>
%1
Explanation Webview or VIEW-Windows initialization failed.
The settings may be corrupted.
Response Correct the settings or restore the factory default settings.
A004 Fault in initial video input systems settings (warning)
initial video input %1 marked inactive
Message
%1 Camera number (1-4)
Explanation Because there was no input for the initial video input system,
VB101 has switched to automatic detection mode. The settings may be corrupted.
Response Correct the settings or restore the factory default settings.
A005 Camera control channel assignment error (warning)
conflicting channel assignment for %1
Message
Camera control port (CC1|CC2)
%1
Explanation The same camera control port is assigned to multiple video input channels.
The settings may be corrupted.
Correct the settings or restore the factory default settings.
Response
A006 Camera control system initialization failure (err)
Message cannot open camera control port %1
Camera control port (CC1|CC2)
%1
Explanation The camera control port cannot be opened.
Response If rebooting does not recover this problem, there is a malfunction. Contact an authorized Canon service representative.
92
A007 View restriction setting error (warning)
inconsistent view restriction for camera[%1]
Message
Camera number (1-4)
%1
Explanation The view restrictions settings are corrupted.
The camera control functions on the affected camera cannot be used.
Restore the factory default settings or reset the permitted field of view restrictions.
Response
A008 Compatibility error in the view restrictions settings (warning)
unacceptable view restriction for camera[%1]
Message
Camera number (1-4)
%1
Even in the telephoto field of view, the view restriction settings cannot be satisfied in the horizontal or vertical direction. When this occurs,
Explanation
the zoom setting is fixed at the telephoto field of view, and camera head control is prohibited in directions that do not satisfy the permitted field of view restrictions.
Set appropriate values for the permitted field of view restrictions.
Response
A010 Camera control driver start and stop (info)
Message %1 driver for camera[%2] %3
Camera type (Canon VC-C1|Canon VC-C3|Canon VC-C4|Canon VC-C4R)
%1
Camera number (1-4)
%2
started|stopped
%3
Explanation The camera control device was detected and the driver started up,
or a camera control device error was detected and the driver stopped.
A011 Camera control device error (warning)
%1[%2] malfunction (%3)
Message
Camera type (VC-C1|VC-C3|VC-C4)
%1
%2 Camera number (1-4)
Error (read|write|timeout|...)
%3
Explanation Camera control device I/O error.
Response If this occurs frequently, this is a malfunction. Contact an authorized Canon service representative.
A014 Access prohibited due to host restriction (notice)
%1@%2 access denied
Message
Client type (LS|VW)
%1
Client host IP address
%2
Explanation Access to the client was denied due to host restrictions . (LS indicates a WebView client,
VW indicates a VIEW-Windows client. Normally, the same message is displayed several times.)
Log Messages
6
93