Log Messages - Canon VB150 User Manual

Log Messages

The Syslog log messages are classified into the following 5 categories. Classification details are dealt with
in the UNIX syslog the levels are explained on page 58 of the VB150 User's Manual.
Classification
crit
err
warning
notice
info
* The syslog facility is local7.
Application-related Log Messages
●A005 Camera control channel assignment error (warning)
Message
%1
%2
Explanation
Response
●A006 Camera control system initialization failure (err)
Message
%1
Explanation
Response
●A007 View restriction setting error (warning)
Message
%1
Explanation
Response
●A008 Compatibility error in the view restrictions settings (warning)
Message
%1
Explanation
23
Response
Fault Severity
Level
Error Critical fault at the software level (stops task operation)
Fault involving a malfunction (operation interrupted)
Error
Fault not involving malfunction
Warning
Warning Fault outside the system
Information on correct operation
Information
conflicting channel assignment for %1: %2
Camera control port (CC1 | CC2)
Cascade number (1-4)
The same camera control port (a combination of camera control port and cascade
number) is assigned to multiple video input channels. Or, the specified cascade
numbers are not in sequence. The settings may be corrupted.
Correct the settings or restore the factory default settings.
cannot open camera control port %1
Camera control port (CC1 | CC2)
The camera control port cannot be opened.
If rebooting does not solve this problem, there is a malfunction. Contact an
authorized Canon service representative.
inconsistent view restriction for camera [%1]
Camera number (1-4)
The view restriction settings are corrupted. The camera control functions on the
affected camera cannot be used.
Restore the factory default settings or reset the view restrictions.
unacceptable view restriction for camera [%1]
Camera number (1-4)
Even in the telephoto field of view, the view restriction settings cannot be satisfied in the horizontal or
vertical direction. When this occurs, the zoom setting is fixed at the telephoto field of view, and camera
head control is prohibited in directions that do not satisfy the permitted field of view restrictions.
Set appropriate values for the view restrictions.