Camera And Video Settings Page - Canon VB101 User Manual

Detail Settings

Camera and Video Settings Page

Use this page to set the camera control parameters and the video image size and quality.
40
Common Settings
"Main Camera"
Specifies the camera selected when the
VB101 starts up.
"Baud rate of camera control port CC1/CC2"
For CC1 and CC2, select the same baud
rate as that set on the camera.
Settings for cameras 1 to 4
The camera1 to 4 correspond to cameras
which are connected to V1 to V4.
"Use this Camera"
When you tick this option, this camera is
used and the settings below are enabled.
"Camera Name"
Used in the camera selection menu in the
WebView Livescope Viewer.
"Wide Converter"
Always select "Used" when a wide
converter is mounted on the camera.
"Video Signal"
Select Auto Detect, NTSC or PAL.
"Video Capture Size"
The available settings are 640x240,
320x240 and 160x120.
"Video Quality"
Enter an adjustment setting between 1
and 99. Higher values give better image
quality but a slower frame rate since the
amount of image data increases.
"Visible range Limitation"
If you tick the "Apply the Visible range Limitation" option, the settings
below are enabled. Use this setting to prevent clients from seeing
certain camera angles.
"Upper value, Lower value, Left value, Right value"
Sets the extent of the field of view provided to users. Enter an angle
between -179.99 and 180.00 for each setting.
(Specify settings so that the upper value is greater than the lower
value and the left value is lesser than the right value.)
"Telephoto, Wide"
Sets the zoom angles provided to users. Enter a horizontal angle
for the field of view of between 0.01 and 300.0 for each setting.
(Specify settings so that the telephoto setting is lesser than or
equal to the wide setting.)
Click the [OK] button to change the settings. To discard the changes, click the
[Cancel] button. This returns you to the settings title page.
Detail Settings
"Control Port"
Four cameras can be connected, but only
two of those can be controlled. When
these cameras are connected to control
port CC1 or CC2, either can be selected.
Select "Not controlled" for cameras that
are not connected or not controlled.
"Home Position"
The reference position for the camera
used at start-up and for picture recording .
When you tick the "Return to Home
position at start-up" option, the settings
below are enabled.
"Pan"
Sets the initial pan position of Camera.
3
Enter an angle between -179.99 and
180.00 degrees.
"Tilt"
Sets the initial tilt position for the
camera. Enter an angle between -
179.99 and 180.00 degrees.
"Zoom"
Sets the initial value for the camera's
angle of zoom. Enter an angle between
0.01 and 300.0.
"Brightness"
Sets the target value for the camera's
auto exposure feature. Select
"Standard" (for bright subjects) or
"Brighter " (for dark subjects).
"Shutter speed "
Sets the camera shutter speed. Select
Auto, 1/60 or 1/100.
"Focus Mode"
Sets the focusing mode for the camera.
Select "Auto" (auto focus) or "Infinity"
(focus fixed at infinity).
41