Canon VB101 User Manual page 50

Log Messages
System-related Log Messages
S001 Ethernet interface initialization failed (crit)
eci: netif can't up
Message
Network interface initialization failed.
Explanation
If rebooting does not resolve the problem, contact an authorized Canon service representative.
Response
S002 Ethernet route registration failure (err)
eci: net route can't add
Message
Explanation An attempt to register a route for a local Ethernet segment failed.
Correct the Ethernet settings and reboot.
Response
S003 Ethernet default route registration failed (err)
eci: default route can't add
Message
Registration of the default Ethernet route failed.
Explanation
Correct the Ethernet settings and reboot.
Response
S004 System startup (info)
System started
Message
Explanation The VB software started up.
S005 System settings changed (info)
System settings updated
Message
Explanation The VB software settings were modified without a reboot.
S006 IP address conflict detection at startup (err)
Detected a conflict for IP address %1 with %2
Message
IP address
%1
Ethernet address
%2
Explanation An IP address conflict was detected during startup. If there is a device running on the network that
has the same IP address as the VB101, this error occurs when the VB101 starts up.
Response Change the VB101 IP address or change the IP address of the conflicting network
device. If you change the VB101 IP address, the VB101 must be rebooted.
When there is an IP address conflict, it may not be possible to modify the settings
via Ethernet. In this event, an initial setup tool must be used to change the settings.
98
S007 IP address conflict detected during operation (err)
Duplicate IP address %1
Message
Ethernet address
%1
Explanation An IP address conflict was detected during operation. This occurs when a network device
with the same IP address as the VB101 is started up after the VB101 was started up.
Response As for S006.
S010 FAT (File Allocation Table) count error (err)
only 2 FATs are supported (FATs=%1)
Message
%1 Number of FATs
Explanation The number of FATs is not 2.
The file system may be corrupted or it may not be formatted as a FAT file system.
Response If this error affects the internal file system, contact an authorized Canon service representative. If it affects a memory card, replace the memory card.
S011 Cluster size error (err)
cluster size is zero
Message
The size of clusters is zero.
Explanation
The file system may be corrupted or it may not be formatted as a FAT file system.
Response If this error affects the internal file system, contact an authorized Canon service representative. If it affects a memory card, replace the memory card.
S012 Sector size error (err)
Message logical sector size is zero
Explanation The sector size is zero.
The file system may be corrupted or it may not be formatted as a FAT file system.
Response If this error affects the internal file system, contact an authorized Canon service representative. If it affects a memory card, replace the memory card.
S013 FAT entry count error (err)
file system has %1 clusters, but only space for %2 FAT clusters
Message
Number of clusters
%1
Number of FAT entries
%2
Explanation The FAT entry recording area for the number of clusters is not allocated.
The file system may be corrupted or it may not be formatted as a FAT file system.
Response If this error affects the internal file system, contact an authorized Canon service representative. If it affects a memory card, replace the memory card.
S014 Root directory size error (err)
root directory size is zero
Message
The root directory size is zero.
Explanation
The file system may be corrupted or it may not be formatted as a FAT file system.
If this error affects the internal file system, contact an authorized Canon service representative. If it affects a memory card, replace the memory card.
Response
Log Messages
6
99