Replacing The Heat Sink - Lenovo 2119 Maintenance Manual

10. Install the screw to secure the new power switch board in the computer.
Figure 196. Installing the screw that secures the power switch board
11. Connect the power switch board cable to the power switch board cable connector on the system board.
See "Locating parts on the system board" on page 92.
12. Secure the new power switch board cable into the cable tie in the computer.
13. Install the hard disk drive into the computer. See "Replacing the hard disk drive bracket" on page 247.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 262.

Replacing the heat sink

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page 1.
This section provides instructions on how to replace the heat sink.
CAUTION:
The heat sink and fan assembly might be very hot. Turn off the computer and wait three to five
minutes to let the computer cool before removing the computer cover.
To replace the heat sink, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 217.
3. Locate the heat sink on the system board. See "Locating major FRUs and CRUs" on page 89.
.
Chapter 11 Replacing FRUs (machine types: 2119, 2121, 3229, 3234, 3235, 3236, 3237, 3238, 3240, 3242, and 3243)
239