Replacing The Hard Disk Drive Bracket - Lenovo 2119 Maintenance Manual

3. Lower the microprocessor retainer, and then lower the lever to secure the retainer. Ensure that the
lever is locked into position.
4. Note the orientation of the socket cover, and install one side of the socket cover into the microprocessor
socket.
Figure 206. Installing one side of the socket cover into the microprocessor socket
Note: Your microprocessor socket and cover might look slightly different from the illustration.
5. Carefully press the other side of the socket cover downward until the socket cover snaps into position.
6. Carefully check the four corners of the socket cover to ensure that the cover is secured in the
microprocessor socket.
7. Follow any additional instructions included with the replacement part you received.

Replacing the hard disk drive bracket

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
on page 1.
This section provides instructions on how to replace the hard disk drive bracket.
To replace the hard disk drive bracket, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See "Removing the computer cover" on page 217.
3. Locate the hard disk drive. See "Locating major FRUs and CRUs" on page 89.
4. Disconnect the signal cable and the power cable from the hard disk drive.
.
Chapter 11 Replacing FRUs (machine types: 2119, 2121, 3229, 3234, 3235, 3236, 3237, 3238, 3240, 3242, and 3243)
247