4.7
Replacing the control panel
Ê Open the server as described in
Ê Remove the following components:
– all of the fans (for a description see the Operating Manual)
– all memory boards and memory dividers (for a description see the
Options Guide)
I
Make a note about the slot from which you pulled each memory
board for you have to replace it back into the same slot.
Ê Remove the fan box (see
Ê Unplug the cable from the back of the control panel.
Figure 11: Removing the control panel
Ê Press on the plastic tabs (1) on both sides of the control panel and push it
outward (2).
To install the control panel follow the above steps in reverse.
RX600 S6
section "Opening the server" on page
page
27).
Service Supplement
Replacement routines
21.
29