Before Setting Surface Controls - Kenmore 790.9750 Series Use & Care Manual

Before Setting Surface Controls

To Set the Cooktop Lockout Feature
The COOKTOP LOCKOUT
being accidentally turned ON. This feature will only lock the cooktop.
To turn the Cooktop Lockout Feature ON:
1. BE SURE ALL surface element controls are set to the OFF position.
2. Press and hold for 3 seconds COOKTOP LOCKOUT
appears in the display (Figure 1). If a triple beep sounds instead, check
all surface elements and turn them to the OFF position and repeat
this step. The two
controls and functions are locked out until the cooktop is unlocked.
Whenever the Cooktop Lockout feature is active, "- -" will appear in all
of the surface element display windows.
To turn the Cooktop Lockout Feature OFF:
1. Press and hold for 3 seconds COOKTOP LOCKOUT
disappears from the display (Figure 2). This will indicate the cooktop
may be used normally.
Note: Starting a Self-Clean cycle will automatically turn ON the Cooktop
Lockout feature. The cooktop will remain locked until the Self-Clean cycle
has completed and the oven door has unlocked.
Note: If a power failure occurs after the Cooktop Lockout has been
activated, you must turn OFF the Cooktop Lockout feature before being able
to use the cooktop features again.
pad is used to activate the Cooktop Lockout feature which will lock all surface elements from
INSTRUCTIONS
will appear in the display indicating the cooktop
(cont'd)
PRESS
until two
for 3 seconds
until the two
for 3 seconds
8
DISPLAy
Figure 1
Figure 2