Download  Print this page

Before Setting Oven Controls; Oven Vent Location - Kenmore 790.4034 Series Use & Care Manual

Gas built-in oven
Hide thumbs

Advertisement

Before setting oven controls

Oven vent location

The oven vent is located under the left side of the control panel
(Figure
2). When the oven is on, warm air passes through this
vent. This venting is necessary for proper air circulation in the
oven and good baking results. Steam or moisture may appear
near the oven vent, this is normal. Do not block oven vent.
Figure 2: Oven vent
Always use pot holders or oven mitts when using
the oven. When cooking, the oven interior and exterior and oven
racks will become very hot which can cause burns.
Protective Liners — Do not use aluminum foil to
line the oven bottom. Only use aluminum foil as recommended
in this manual. Improper installation of these liners may result in
risk of electric shock or fire. Do not line the oven walls, racks,
bottom, or any other part of the oven with aluminum foil. Doing
so will alter heat distribution, produce poor baking results, and
may cause permanent damage to the oven interior. During self
clean temperatures, the oven will be hot enough to melt foil.
Type of oven racks
flat oven rack
oven vent
location
Figure 3: Types of flat oven racks
The flat oven rack (some models) or flat handle oven rack (some
models) may be used for most cooking needs.
Removing, arranging and replacing racks:
Arranging - always arrange the oven racks when the oven is
cool (prior to operating the oven.
To remove - pull the rack forward until it stops. Lift up front of
rack and slide out.
To replace - fit oven rack onto the rack guides on both sides of
oven walls. Tilt the front of oven rack upward and slide the rack
back into place. Be sure oven racks are level before using.
flat handle
oven rack
12

Advertisement

loading