Advertisement
Before Setting Oven Controls
Oven Vent Location
The oven vent is located below the control panel
When the oven is on, warm air passes through this vent. This
venting is necessary for proper air circulation in the oven and
good baking results. Do not block oven vent. Steam or moisture
may appear near the oven vent. This is normal.
Figure 1: Oven vent location
Protective Liners — Do not use aluminum foil to
line the oven bottom. Only use aluminum foil as recommended
in this manual. Improper installation of these liners may result in
risk of electric shock, or fire.
Do not line the oven walls, racks, bottom, or any
other parts of the range with aluminum foil. Doing so will alter
heat distribution, produce poor baking results, and may cause
permanent damage to the oven interior. During self clean
temperatures the oven will be hot enough to melt foil.
Always use pot holders or oven mitts when using
the oven. When cooking, the oven interior, exterior, and oven
racks will become very hot which can cause burns.
Important: Remove all racks and accessories from the oven
before starting a cleaning cycle.
'
Arranging, Removing, and Replacing Racks
To arrange - always arrange the oven racks when the oven is
(Figure
1).
cool.
To remove - pull the rack forward until it stops. Lift up front of
rack and slide out.
To replace - fit oven rack onto the rack guides on both sides of
oven walls. Tilt the front of oven rack upward and slide the rack
back into place. Be sure oven racks are level before using.
Type of Oven Racks
•
To maximize oven cooking space place the oven rack in the
lowest rack position for roasting large cuts of meat.
7
Before Setting Oven Controls
flat handle
oven rack
Advertisement
