D-Fi™ 2.4 Ghz (Dmx Mode Auto Sync) - Chauvet Freedom Par RGBA User Manual

D-Fi™ 2.4 GHz
(DMX Mode
Auto Sync)
Freedom™ Par RGBA and Strip Mini RGBA User Manual Rev. 4
The Freedom™ RGBA series offers wireless control of 2 or more products with a single
DMX controller. To automatically set up the D-Fi™ syncing function for DMX
functionality, do the following:
For the transmitting product:
1. Press <MODE> repeatedly until SYS, ACt, ACtC, SLAv, or S-Ir shows on the
display.
2. Use <UP> or <DOWN> to select SYS.
3. Press <ENTER>.
4. Press <UP> or <DOWN> until S-tr appears on the display.
5. Press <ENTER>.
6. Press <UP> or <DOWN> until dtA.S shows on the display.
7. Press <ENTER> and dt.AU shows on the display.
For the receiving product(s):
1. Press <MODE> repeatedly until SYS, ACt, ACtC, SLAv, or S-Ir shows on the
display.
2. Use <UP> or <DOWN> to select SYS.
3. Press <ENTER>.
4. Press <UP> or <DOWN> until S-tr shows on the display.
5. Press <ENTER>.
6. Press <UP> or <DOWN> until drA.S shows on the display.
7. Press <ENTER> and dr.AU shows on the display.
8. Press <AUTO> for approximately 10 seconds to set the receiving product.
Once the steps above are done, press and hold <AUTO> on just the transmitting
product for approximately 30 seconds. The display and signal LED will flash to indicate
sync is activated.
You can then back out to a general menu level and configure the transmitting product to
operate it with a DMX controller.
To configure your product to work with DMX, refer to the
manual.
·
To add additional compatible Freedom™ products, turn the synced ones off
and repeat the above steps with unsynced products. Once all products are
synced, turn them all back on.
·
Auto scan syncing must be done within a distance of about 32 ft (10 m).
Note: Auto syncing signals might be blocked if the transmitting product and
the receiving product are too close to each other. If they are unable to
become synchronized, move them farther apart and try syncing them again.
·
If you are experiencing antenna issues or need to improve signal quality,
extend the antenna outward away from the product and keep the line of sight
between products unobstructed.
·
Ensure that all linked products are configured to the same DMX personality
(either 4-channel or 5-channel).
·
Caution: D-Fi™ operation can be interrupted or inhibited by liquid masses
between the transmitter and receiver such as water, snow, or people. For best
results, please keep the antenna clear of any liquid mass.
Starting Address section of this
Page 25 of 88