D-Fi 2.4 Ghz (Dmx Mode Auto Sync) - Chauvet Freedom Par Quad 4 IP User Manual

D-Fi 2.4 GHz
(DMX Mode
Auto Sync)
Page 12 of 20
The Freedom Par Quad-4 IP offers wireless control of 2 or more products with a single
DMX controller. To automatically set up D-Fi 2.4 GHz syncing for DMX, do the following:
For the receiving product(s):
1. Press <MENU> repeatedly until S-tr shows on the display.
2. Press <ENTER>.
3. Press <UP> or <DOWN> until drAS appears on the display.
4. Press <ENTER>.
5. The display should show drAU.
For the transmitting product:
1. Press <MENU> repeatedly until S-tr shows on the display.
2. Press <ENTER>.
3. Press <UP> or <DOWN> until dtAS appears on the display.
4. Press <ENTER>.
5. The display should show dtAU.
Receiving units must be set up before the transmitting unit. Once the steps above are
done, press and hold <AUTO> on just the transmitter for approximately 30 seconds. The
display and signal LED will flash to indicate sync is activated.
You can then back out to a general menu level and configure the transmitting product to
operate it with a DMX controller.
To configure your product to work with DMX, refer to the
·
To add additional Freedom products, turn the synced ones off and repeat the above
steps with un-synced products. Once all products are synced, turn them all back on.
·
Auto scan syncing must be done within a distance of about 32 ft (10 m).
·
Manual syncing is recommended for best results when adding products after initial
system setup.
·
If you are experiencing issues or need to improve signal quality, keep the line of sight
between products unobstructed.
·
Ensure that all linked products are configured to the same DMX personality.
Caution: D-Fi 2.4 GHz operation can be interrupted or inhibited by liquid masses between
the transmitter and receiver such as water, snow, or people. For best results, keep the line
of sight clear of any liquid mass.
Starting Address
Freedom Par Quad-4 IP User Manual Rev. 3
section.