Display Orientation; Master/Slave Mode; Reset Software - Chauvet Intimidator Spot LED 150 User Manual
Hide thumbs
Also See for Intimidator Spot LED 150:
- Quick reference manual (61 pages) ,
- User manual (26 pages) ,
- User manual (18 pages)
Table of Contents
Advertisement
Display
Orientation
Master/Slave
Mode
Reset Software
Intimidator™ Spot LED 150 User Manual (Rev. 5)
You are able to flip the LED display for easy readability in any mounting situation.
To select your display angle:
1.
Press <MODE/ESC> repeatedly until diS shows on the display.
2.
Press <UP> or <DOWN> to select normal display mode (diS) or inverse display
mode (r diS).
3.
Press <ENTER>.
The Master/Slave mode allows a single Intimidator™ Spot LED 150 unit (the "master") to
control the actions of one or more Intimidator™ Spot LED 150 units (the "slaves")
without the need of a DMX controller. The master unit will be set to operate in either
Automatic or Sound Active mode, while the slave units will be set to operate in Slave
Mode. Once set and connected, the slave units will operate in unison with the master
unit.
Configure the units as indicated below.
Slave units:
1.
Press <MODE/ESC> repeatedly until SLAv shows on the display.
2.
Press <ENTER> to accept.
3.
Set the DMX address to 001.
4.
Connect the DMX input of the first slave unit to the DMX output of the master unit.
5.
Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
6.
Finish setting and connecting all the slave units.
Master unit:
1.
Set the master unit to operate in either Automatic or Sound mode.
2.
Make the master unit the first unit in the DMX daisy chain.
•
Configure all the slave units before connecting the master unit to the DMX
daisy chain.
•
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the
master unit.
•
Do not connect more than 31 slave units to the master unit.
To reset the software on the Intimidator™ Spot LED 150, do the following:
1.
Press <MODE/ESC> repeatedly until rESt shows on the display.
2.
Press <ENTER>. The product will reset all settings in the software to the default
factory settings.
Page 15 of 18
Advertisement
Table of Contents
