Mounting; Orientation; Rigging; Procedure - Chauvet Rogue R3 Spot User Manual

If you are not familiar with or need more information about DMX standards,
Master/Slave connectivity, or the DMX cables needed to link this product to a
DMX controller, download the DMX Primer from the Chauvet website:
www.chauvetprofessional.com.
Remote Device Management (RDM)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate
bi-directionally along existing DMX cabling. Check the DMX controller's User Manual or with the
manufacturer as not all DMX controllers have this capability. The Rogue R3 Spot supports RDM protocol
that allows feedback to make changes to menu map options.

Mounting

Before mounting the product, read and follow the safety recommendations indicated in the Safety Notes.
For our CHAUVET Professional line of mounting clamps, go to http://trusst.com/products/.

Orientation

Always mount this product in a safe position, making sure there is adequate room for ventilation,
configuration, and maintenance.

Rigging

Chauvet recommends using the following general guidelines when mounting this product.
• Before deciding on a location for the product, make sure there is easy access to the product for
maintenance and programming purposes.
• Make sure that the structure onto which you are mounting the product can support the product's
weight. See the Technical Specifications
• When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, whether an elevated platform or a truss.
• When rigging the product onto a truss, use a mounting clamp of appropriate weight capacity.
• When power linking multiple products, mount the products close enough for power linking cables to
reach.
• The bracket adjustment knobs allow for directional adjustment when aiming the product to the
desired angle. Only loosen or tighten the bracket knobs manually. Using tools could damage the
knobs.

Procedure

The Rogue R3 Spot comes with a preinstalled mounting surface to which you will be able to attach the
included omega bracket. Make sure the clamps are capable of supporting the weight of this product. Use
at least 2 mounting points per product. In addition, use a safety cable to link the product to the structure.
For the CHAUVET Professional line of mounting clamps, go to
Page 7 of 27
for weight information.
http://www.trusst.com/products.
Rogue R3 Spot User Manual Rev. 1
S
ETUP