Table of Contents
Advertisement
Mounting
Orientation
Rigging
Secondary bracket
(used primarily for
standing position)
Do not use a tool
adjustment knob
3. Setup
All manuals and user guides at all-guides.com
The LED PAR 38-18 B/C may be mounted in any safe position provided there is adequate
room for ventilation.
Be sure that the structure can support the weight of the fixture. Please see the "Technical
Specifications" section of this manual for a detailed weight listing. Mount the fixture
securely. This may be done with a screw, nut and bolt, or a hanging clamp. The hole in
each bracket is 13 mm in size. When rigging consider routine maintenance and control
panel access. Please see the following steps for installation.
Be sure to orient the gel frame release so that it is pointing up. Please see the
diagram below for a visual reference.
If the power link out is intended to be used with multiple fixture, take into account the
length of each power cable, and mount the fixtures close enough to one another to
accommodate for this.
When aiming the fixtures, you may use the bracket adjustment knob. Loosen the
knob, adjust to the desired angle, and then tighten the knob by turning clockwise. Do
not use tools for this step, as it may cause damage.
There is a secondary portion of the bracket, which may be used primarily for floor
standing positions.
Safety cables must always be used.
Mounting
Bracket
on the bracket
9
Aim the fixture with
the gel frame
release pointing up,
(as shown in this
diagram)
4/19/2010 2:01 PM
Advertisement
Table of Contents
