Configuration (Dmx); Starting Address; Dmx Personalities - Chauvet Intimidator Spot LED 150 User Manual

Configuration
(DMX)

Starting Address

DMX
Personalities
Page 10 of 18
Set the product in DMX mode to control with a DMX controller.
1. Connect the product to a suitable power outlet.
2. Turn the product on.
3. Connect a DMX cable from the DMX output of the DMX controller to the DMX input
socket on the product.
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product's channels.
The Intimidator™ Spot LED 150 uses up to 11 DMX channels in its 11-channel DMX
mode, which defines the highest configurable address to 502.
If you are not familiar with the DMX protocol, you may refer to the DMX Primer online at
www.chauvetlighting.com.
To select the starting address, do the following:
1. Press <MODE/ESC> repeatedly until 001 shows on the display.
2. Press <ENTER>.
3. Use <UP> or <DOWN> to select the starting address.
4. Press <ENTER>.
The Intimidator™ Spot LED 150 has two DMX personalities, an 8-channel personality and
a 14-channel personality.
To choose which DMX personality to use, follow the steps below:
1. Press <MODE/ESC> repeatedly until either 14CH (to choose the 14-channel
personality) or 8CH (to choose the 8-channel personality) shows on the display.
2. Press <ENTER>.
Intimidator™ Spot LED 150 User Manual (Rev. 5)