Setup; Ac Power; Fuse Replacement; Power Linking - Chauvet Intimidator Spot LED 150 User Manual

3. S
ETUP

AC Power

Fuse
Replacement

Power Linking

Power Linking
Diagram
Intimidator™ Spot LED 150 User Manual (Rev. 5)
The Intimidator™ Spot LED 150 has an auto-ranging power supply and it can work with
an input voltage range of 100~240 VAC, 50/60 Hz.
To determine the product's power requirements (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product's back panel, or
refer to the product's specifications chart. The listed current rating indicates the
product's average current draw under normal conditions.
Always connect the product to a protected circuit (circuit breaker or fuse). Make
sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0~100% switch.
Disconnect the product from power before replacing the fuse.
1. Using a flat-head screwdriver, unscrew the fuse holder from the back of the product.
2. Remove the blown fuse from the holder and replace with a fuse of the exact same
type and rating.
3. Insert the fuse holder back in place, re-tighten, and reconnect power.
The product provides power linking via the Edison outlet located in the back of the unit.
Please see the diagram below for further explanation.
st
1 Product
You can power link up to 6 Intimidator™ Spot LED 150 units on 120 VAC or up to
12 Intimidator™ Spot LED 150 units on 230 VAC.
The power linking diagram shown above corresponds to the North American
version of the product ONLY! If using the product in other markets, you must
consult with the local CHAUVET® distributor as power linking connectors and
requirements may differ in your area.
nd rd
2 Product 3 Product
Other products
Page 7 of 18