Table of Contents
Advertisement
MP25
CLUB MIXER
XLR WIRING
PIN 2 = POSITIVE
PIN 3 = NEGATIVE
PIN 1 = GROUND
R
ACN 001
DIGITAL INPUTS
345 482
D1-D4
THIS DEVICE
COMPLIES WITH
PART 15 OF THE
FCC RULES.
100-240 V
USB
50/60 Hz 12 WATTS
Outputs
Main/Zone/Booth
All analog outputs come from the same "Main Mix" signal.
Main
,
Booth
and
Zone
Outputs each have their own
trol.
The
output is from unbalanced RCA and balanced
Main
XLR jacks with pin 2 "hot" per AES standards (XLR preferred*).
If the Main output feeds a mono PA system, engage the
switch on the rear of the MP25. If the Main output is able to
clip the input to the PA system when the front panel
control is at maximum, reduce the maximum output level using
the rear panel
control.
Max Out
The
and
outputs are from balanced ¼˝ TRS (tip-
Booth
Zone
ring-sleeve) jacks. Booth and Zone outputs include auto-mono on
both left and right connections. Plug in only one side to receive a
mono signal. Plug into both jacks to receive a stereo signal.
*Rane recommends balanced wiring for the strongest signal
and rejection of hum and noise. If your cable to the amp rack
is less than 10 feet (3 meters), you can usually get away with an
unbalanced cable with RCA or ¼˝ TS (tip-sleeve) plugs. See the
RaneNote "Sound System Interconnection" included with this
manual or at www.rane.com for details on cable wiring.
Record Outputs
Record outputs are a direct feed from the main mix. There are
no level controls between the mix and these outputs. The main
mix is available in three different formats for recording: unbal-
anced analog RCA, 24-bit 48 kHz S/PDIF, and USB (on record
channel six).
FlexFX Send/Return
The MP25's FlexFX Loop includes an analog insert loop for use
with outboard effects processors. The Send and Return signals
are on stereo unbalanced ¼˝ TS jacks. The Left and Right Send
jacks provide auto-mono operation. Simply plug in one side for
mono, or both sides for stereo. The Return jack provides similar
operation. Plugging into either the left or right return jack sends
the signal to both the left and right FlexFX Loop return chan-
nels. Plugging into both jacks separates the left and right return
channels.
Manual-2
MONO
STEREO
SEND
RETURN
L
MAIN OUTS
L
RECORD OUTS
R
FLEXFX
S/PDIF
ANALOG
Level
con-
Mono
Main Level
MAX OUT dB
0
-24
R
L
R
ZONE OUT
BOOTH OUT
L
L
L
LINE
PHONO
R
R
R
A4
A3
A2
A1
P4
P3
USB
Connect your computer to the USB port on the MP25 to send
up to twenty-two channels of audio to/from your favorite multi-
track mixing, beat-making, looping, sampling, and record-
ing software applications. Install the MP25 ASIO (Windows)
or Core Audio (Macintosh) drivers (instructions later in this
manual), so that your computer recognizes the MP25.
Digital Inputs
The MP25's USB audio interface includes five stereo playback
channels. Playback channels are audio streams from the com-
puter to the MP25. Four of these five channels are
MP25's digital program inputs. Each of the four program strips
has access to one of the four digital input channels using the
Source
selector on the program strip. The fifth stereo playback
channel is the return channel of the FlexFX USB insert loop.
Digital Outputs
The MP25's USB audio interface includes six stereo record chan-
nels. Record channels are audio streams from the MP25 to the
computer. Four of these five channels are post-fader record chan-
nels from the MP25's program strips. These four record streams
may be used to multi-track record your set for post-production
editing and mix-down. The fifth USB record channel is the send
channel of the FlexFX USB insert loop. The sixth record channel
may be used to record the Main Mix (default), Mic 1, or Mic
2. Select the record source for USB record channel 6 using the
MP25 driver control panel on your computer.
MIDI
In addition to being an audio interface, the MP25 front panel is
also a USB MIDI controller. The Zone Level, Main Balance and
Main Level controls are the only front panel controls not MIDI
enabled. See MIDI Implementation later in this manual.
Power Supply
The MP25 features an internal universal switching power supply
that operates on any AC mains 100 to 240 VAC, 50 or 60 Hz
(most places in the world). All that is required when traveling
between different countries is the appropriate power cord, which
is usually readily available.
PHONO
GROUND
L
L
LINE
LINE
MIC
PHONO
PHONO
LINE
R
P2
P1
MIC 2
D1
MP25
MADE IN U.S.A.
RANE CORP.
MIC 1
-
, the
D4
Advertisement
Table of Contents
