Rane MP25 Operator's Manual

MP25 Overview
The MP25 is a compact, 4U, rack mountable, four channel
mixer; featuring a twenty-two channel, high-speed USB audio
interface with low-latency ASIO and Core Audio drivers. There's
no "Quick Start" here, we recommend you read this relatively
short manual to get all this mixer is capable of.
Key Features
• High-speed USB 2.0 interface
• 6 stereo Record channels
• 5 stereo Playback channels
• MIDI-enabled mixer controls
• Four full-featured program strips
• Four stereo Phono/Line Inputs
• Four stereo Auxiliary Inputs
• Four stereo USB playback Inputs
• Gain Level, 3-band EQ, and High-pass/Low-pass Filter
• Crossfader, Cue, and FlexFx Assign
• 60 mm long-throw channel faders
• Two fully independent Mic Inputs
• One with front and rear panel jacks
• One with available line-level input
• Independent Level, Pan, EQ, Engage, and FlexFx Assign
• Talkover mode engages the mic and automatically ducks
all other program inputs.
• Advanced FlexFx architecture
• External Analog Insert (with Send & Return level controls)
• USB Insert
• Meter, Cue, Engage and FlexFx Level controls
• Headphone monitor with Split Cue option
WEAR PART
This product contains no wear parts as described in the Warranty.
OPERATORS MANUAL
Connecting the Mixer
Leave the power unplugged until everything else is connected
Inputs
Phono/Line Inputs (P1-P4)
The MP25 has four stereo Phono/Line inputs (
Any of these analog inputs may be set for Phono Input or Line
Input (for CD players) using the push switches located on the
rear panel. Unused inputs are best set to
table's ground wires to the
four program strips has access to one of the Phono/Line Inputs
using the program strip's
Source
Auxiliary Inputs (A1-A4)
The MP25 has four stereo Auxiliary analog inputs (
). Each of the four program strips has access to all of the Aux-
A4
iliary Inputs using the program strip's
Mic Inputs (MIC 1 and MIC 2)
The Mic Inputs accept XLR 3-pin plugs, balanced ¼" TRS
(tip-ring sleeve) plugs or unbalanced TS (tip-sleeve) plugs.
has two input jacks, one on the front panel and one on the rear.
Only use one Mic 1 input jack at a time.
line-level option.
MP25
CLUB MIXER
, ,
P1 P2
. Attach your turn-
Line
Phono Ground connectors. Each of the
selector.
A1
Source selector.
Mic 2 has a switchable
, ).
P3 P4
, , ,
A2 A3
Mic 1
Manual-1