Keypad Control Tones (Beeps) - GE NX-1300E User Manual

Networx series led keypad

Hide thumbs

Table Of Contents

Table of Contents

ZONE TAMPER - Press the [2] key and the zone light(s) will

illuminate showing the zone(s) that are tampered. Press the [#]

key to return to the 1 of 8 service lights.

ZONE LOW BATTERY - Press the [3] key. The zone light(s) will

illuminate showing which zone(s) has a low battery.

applies to wireless zones. Press the [#] key to return to the 1 of 8

service lights.

ZONE LOSS OF SUPERVISION - Press the [4] key and the zone

light(s)

supervision. This only applies to wireless zones. Press [#] key to

return to the 1 of 8 service lights.

ZONE TROUBLE - Press the [5] key and the zone light(s) will

illuminate showing which zone(s) has a trouble condition. Press the

[#] key to return to the 1 of 8 service lights.

TELEPHONE LINE TROUBLE/LINE CUT – Press the [6] key. The

zone light(s) will illuminate as they correspond to these service

conditions:

1-5 = Reserved

The service light will remain lit until the trouble clears and a user

code is entered. * SEE NOTE.

FAILURE TO COMMUNICATE - This light will illuminate when

there is a failure to communicate between your system and the

central station. * SEE NOTE.

LOSS OF SYSTEM TIME - This light will illuminate when there

has been a loss of power and your system clock needs to be reset.

Instructions are on page 16. * SEE NOTE.

* NOTE to Lights 6,7,8: This fault is global in nature and will affect all

partitions of a multi-partition system.

A sounder is built into the keypad. If programmed, your system keypad may

sound for any of the following reasons:

Beeps for all keypresses.

Sounds a continuous tone during the Entry delay time.

Pulses when a day zone is violated while the system is disarmed.

Pulses when a FIRE zone has a trouble condition.

will

illuminate