movistar RTA01N User Manual page 92

User's Guide
Field Description
Disable WPS Check to disable the Wi-Fi protected Setup.
When AP's settings are factory default (out of box), it is
WPS Status
set to open security and un-configured state. "WPS
Status" will display it as "UnConfigured". If it already
shows "Configured", some registrars such as Vista
WCN will not configure AP. Users will need to go to the
"Backup/Restore" page and click "Reset" to reload
factory default settings.
Self-PIN Number "Self-PIN Number" is AP's PIN. Whenever users want
to change AP's PIN, they could click "Regenerate PIN"
and then click " Apply Changes". Moreover, if users
want to make their own PIN, they could enter four-digit
PIN without checksum and then click " Apply
Changes". However, this would not be recommended
since the registrar side needs to be supported with
four-digit PIN.
"Self-PIN Number" is AP's PIN. Whenever users want
Push Button
to change AP's PIN, they could click "Regenerate PIN"
Configuration
and then click " Apply Changes". Moreover, if users
want to make their own PIN, they could enter four-digit
PIN without checksum and then click " Apply
Changes". However, this would not be recommended
since the registrar side needs to be supported with
four-digit PIN.
Push Button Clicking this button will invoke the PBC method of
Configuration WPS. It is only used when AP acts as a registrar.
Client PIN It is only used when users want their station to join
AP's network. The length of PIN is limited to four or
Number
eight numeric digits. If users enter eight-digit PIN with
checksum error, there will be a warning message
popping up. If users insist on this PIN, AP will take it.
Function Button Description
Regenerate PIN Click to regenerate the Self-PIN Number.
Start PBC Click to start the Push Button method of WPS.
Apply Changes Click to commit changes.
Reset It restores the original values.
Start PIN Click to start the PIN method of WPS.
Configuring your Computers
92