movistar RTA01N User Manual page 110

User's Guide
Fields on the Description
first setting
block
Enable Check to enable the selected route or route to be
added.
Destination The network IP address of the subnet. The destination
can be specified as the IP address of a subnet or a
specific host in the subnet. It can also be specified as
all zeros to indicate that this route should be used for
all destinations for which no other route is defined (this
is the route that creates the default gateway).
Subnet Mask The network mask of the destination subnet. The
default gateway uses a mask of 0.0.0.0.
Next Hop The IP address of the next hop through which traffic
will flow towards the destination subnet.
Metric Defines the number of hops between network nodes
that data packets travel. The default value is 0, which
means that the subnet is directly one hop away on the
local LAN network.
Interface The WAN interface to which a static routing subnet is
to be applied.
Function Description
buttons
Add Route Add a user-defined destination route.
Update the selected destination route on the Static
Update
Route Table.
Delete Selected Delete a selected destination route on the Static
Route Table.
Click this button to view the DSL device's routing table.
Show Routes
The IP Route Table displays, as shown in Figure.
2. Click on Show Routes. The following page is displayed:
Configuring your Computers
110