Loading A Cd; Playback - Tascam CD-200i Owner's Manual

4 − Playing Back CDs

Loading a CD

OPEN/CLOSE
To load a CD, press the
or on the remote control to open the disc tray, and put the
CD into the tray with the label facing up.
OPEN/CLOSE
Press the key again to close the disc tray.
After loading the disc, the unit reads the disc's information
and shows on the display the total number of tracks and
total playback time if it is an audio CD and the total number
of tracks in the current folder if it is a data CD.
OPEN/CLOSE key
Instead of pressing the OPEN/CLOSE key to close the disc
tray, you can press the PLAY/READY key to close the disc
tray and begin playback immediately.
CAUTION
If you open the disc tray while this unit is in use, the
following settings are lost.
– Program
– Current folder (for data CDs)
22
TASCAM CD-200i
key on the main unit
OPEN/CLOSE key

Playback

The following procedures assume that the necessary
connections have been completed, the unit's power has been
turned on and a CD (audio or data) has been loaded.
PLAY/READY
Press the
remote control to begin playback of a CD.
Stopping playback:
ª
STOP
Press the key on the main unit or the remote
control.
Pausing playback:
ª
PLAY/READY
Press the
remote control.
In this manual, unless stated otherwise, explanations are
given assuming that continuous playback mode is set. (See
"Playback modes" on page 25.)
key on the main unit or
PLAY/READY key
PLAY/READY key
key on the main unit or the