Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Tascam CD-200
Summary of Contents for Tascam CD-200
- Page 1 D01064220F CD-200 Compact Disc Player OWNER’S MANUAL...
- Page 2 APPAREIL NUMERIQUE DE LA CLASSE A EST CONFORME A LA NORME NMB-003 DU CANADA. Supplier’s Declaration of Conformity CE Marking Information Model Number: CD-200 a) Applicable electromagnetic environment: E4 Responsible party: TEAC AMERICA, INC. Address: 10410 Pioneer Blvd., Unit #1, Santa Fe b) The average half-cycle r.m.s.
- Page 3 CAUTION normally, or has been dropped. • Leave 1U of space above the unit for ventilation. • Allow at least 10 cm (4 in) at the rear of the unit for ventilation. TASCAM CD-200...
- Page 4 WARNING • Do not disassemble a battery. The acid inside the battery could harm skin or clothing. To prevent possible hearing damage, do not listen at high volume levels for long periods. TASCAM CD-200...
- Page 5 (e) Return and collection systems are available to end users. For more detailed information about the disposal of old electrical/electronic equipment and waste batteries/ accumulators, please contact your city office, waste disposal service or the shop where you purchased the equipment. TASCAM CD-200...
-
Page 6: Table Of Contents
General .................26 Trademarks ................7 Dimensions .................27 Using the TEAC Global Site ..........7 About TASCAM customer support service ....7 Precautions and notes for placement and use ..8 Beware of condensation ........... 8 Cleaning the unit ..............8 About discs ................ -
Page 7: Introduction
1 − Introduction 1 − Introduction • When the alphanumeric portion of the display shows a Thank you for your purchase of the TASCAM CD-200 Compact Disc Player. message, this is shown in the following typeface: OPEN • If a preset indicator in the display (i.e. one which cannot... -
Page 8: Precautions And Notes For Placement And Use
About discs In addition to audio CDs (CD-DA), the CD-200 can play CD-R and CD-RW discs on which audio CD, MP3, or WAV format files are recorded. The CD player can also play 3-inch CDs Handling of compact discs •... -
Page 9: Names And Functions Of Parts
When the function is on, the indicator will light. Adjust the amount (±12.5%) by turning the knob. (See “Pitch control” on page 23.) Remote Sensor When operating the remote control unit, point it towards here. Display Displays various information. TASCAM CD-200... -
Page 10: Rear Panel
The CD playback signal is output here as a digital signal in S/ PDIF format. VOLTAGE SELECTOR Switches the voltage to either 230 V or 120 V. NOTE • The voltage selector is only available on units for specific markets. • In North America, use only on 120V supply. TASCAM CD-200... -
Page 11: Remote Control Unit (Rc-Cd200)
Press this key to select single repeat or all repeat playback. Press this key again to stop repeat playback. (See “Repeat playback” on page 22.) STOP Use this key to stop playback. PLAY/READY Use this key to start or pause playback. TASCAM CD-200... -
Page 12: Display
, etc.) and OPEN CLOSE READ messages ( , etc.) are also shown. Items with more NO DISC than eight characters are scrolled when shown. * TOC means “Table Of Contents,” which is track information written on the disc TASCAM CD-200... -
Page 13: Preparation For Use
CAUTION • When making a digital connection, use either the coaxial or optical connector. • To dub a recording digitally, prepare the disc for playback in this unit before starting recording with the recording device. TASCAM CD-200... -
Page 14: Preparing The Remote Control
Operation distance otherwise be damaged. Please read and abide by the precau- Directly in front: Within 7 meters tions on them when using batteries. Also see “CAUTIONS ABOUT BATTERIES” on page 4. 15° left or right: Within 7 meters TASCAM CD-200... -
Page 15: Playing Back Cds
VBR files. For this reason, the point where playback actually starts might differ slightly from the point set in advance for functions of this player when points must be set in the middle of a track. <An Example of Data CD Structure> TASCAM CD-200... -
Page 16: Loading A Cd
(See “Playback modes” on page 18.) CAUTION If you open the disc tray while this unit is in use, the following settings are lost. • Program • Current folder (for data CDs) TASCAM CD-200... -
Page 17: Selecting A Track
(Ô/Â, ¯/) key on the remote control to start searching forward or backward. 3. Release the key that you are holding to stop searching and return the unit to the state it was in before searching (playback or pause). TASCAM CD-200... -
Page 18: Folder Playback (With Data Cds Only)
If you hold down one of these keys, you can skip through folders continually. NOTE When you skip to a different folder, it becomes the current PLAY MODE folder. INTRO CHECK key PLAY MODE INTRO CHECK key TASCAM CD-200... -
Page 19: Programmed Playback
1. Press the PROGRAM EDIT key while playback is stopped. PROGRAM EDIT key The unit enters program setting mode, and if no program has been set, it will be possible to set a track to program step 01 (MEMORY indicator blinks). [Audio CD] TASCAM CD-200... -
Page 20: Checking The Program
• The same track can be added to the program multiple times. • If you press the STOP key when the empty program step where it is possible to add a track appears, all steps in the program are cleared. TASCAM CD-200... -
Page 21: Replacing A Program Track
In addition to the above procedure, opening the disc tray also clears the program. When stopped, the display switches between total number of tracks and album title (current folder). When playing back or paused, the display cycles through track elapsed time, title, artist and file. TASCAM CD-200... -
Page 22: Repeat Playback
Then, playback continues from the beginning of the disc or current folder. If repeat playback is turned ON when stopped, repeat playback begins when the PLAY/READY key is pushed. • The repeat function’s ON/OFF state is retained even when the power is turned OFF. TASCAM CD-200... -
Page 23: Pitch Control
• When using Intro Check, press the SEARCH Ô/ (Â/¯) keys on the main unit or the search (Ô/Â, ¯/) keys on the remote control to skip to the preceding or next track. • Press the STOP key to stop Intro Check. TASCAM CD-200... -
Page 24: Message Lists
If one of the following error messages is shown, please refer to the Response column and try to resolve it. If these measures do not solve the problem, please contact the store where you purchased this unit or TASCAM customer support service. - Page 25 If you are having trouble with the operation of this unit, please try the following before seeking repair. If these measures do not solve the problem, please contact the store where you purchased this unit or TASCAM customer support service. No power e Check the connection to the AC power supply.
- Page 26 Maximum Output Level: +6 dBV 5° or less Output Impedance: 200Ω • Illustrations and other depictions may differ in part from the actual product. • Specifications and external appearance may be changed without notification to improve the product. TASCAM CD-200...
- Page 27 IMPORTANT SAFETY INSTRUCTIONS 7 − Specifications Dimensions TASCAM CD-200...
- Page 28 CD-200 TEAC CORPORATION https://tascam.jp/jp/ Phone: +81-42-356-9143 1-47 Ochiai, Tama-shi, Tokyo 206-8530, Japan TEAC AMERICA, INC. https://tascam.com/us/ Phone: +1-323-726-0303 10410 Pioneer Blvd., Unit #1, Santa Fe Springs, California 90670, U.S.A TEAC UK Ltd. https://www.tascam.eu/en/ Phone: +44-1923-797205 Luminous House, 300 South Row, Milton Keynes, Buckinghamshire, MK9 2FR, UK TEAC EUROPE GmbH https://www.tascam.eu/de/...