Connecting To The Dataport Of The Dsp-4 - QSC DSP-4 Hardware Manual

INSTALLATION-
When using the DSP-4 module with QSC's amplifier network monitors, the audio input to the module can be delivered
through the DataPort along with amplifier control and monitoring signals. This is the normal application of the DataPort.
Connection from the module to the amplifier network monitor is made using a DPC-X male-male QSC DataPort cable.
Alternatively, the DataPort connection can be used ONLY for control and monitoring, while the audio is input via the XLR
inputs. If using the DSP-4 in this manner, do not apply audio via the DataPort as it will be mixed with the XLR audio input
signals.
The DSP-4's DataPort output (rear panel DataPort) connects directly to QSC's 2-channel, 2RU, DataPort equipped
amplifiers when mounting the module on the rear of the amplifier. For all other QSC DataPort equipped amplifiers, the
module is mounted on an accessory bracket and module-to-amplifier connection is made with a DPX-2 male-female
QSC DataPort cable. These connections are shown on the previous page.
If you are using the DataPort for audio input and/or control and monitoring, you need to:
1-
Orient the DataPort connector with the DataPort jack.
2-
Firmly insert the connector into the jack.
3-
Tighten the connector's retaining screws to ensure proper contact is made. Do not overtighten.
Do not use computer VGA cables as they are not correctly constructed for use with the DSP-4.
QSC DataPort cables may be obtained through your QSC distributor or by calling QSC's Technical Services Department.
DataPort Connections
13