Chapter 2 Installation; Table 2.1: Eki-7529Mi, Eki-7529Mi/St Led Definition; Table 2.2: Eki-7529Mi, Eki-7529Mi/St Dip Definition - Advantech EKI-7529MI User Manual

Chapter 2
In this chapter, you will be given an overview of the EKI-7529MI, EKI-7529MI/ST
hardware installation procedures.
2.1 LED Indicators
There are few LEDs display the power status and network status located on the front
panel of EKI-7529MI, EKI-7529MI/ST, each of them has its own specific meaning as
the table below.

Table 2.1: EKI-7529MI, EKI-7529MI/ST LED Definition

LED Color
PWR1 Green
PWR2 Green
P-Fail Red
Link/Active
Green
(9, 10)
Link/Active
Green
(1~8)
Duplex/Collision
Yellow
(1~8)

Table 2.2: EKI-7529MI, EKI-7529MI/ST DIP Definition

DIP Function
DIP 1(Port 1 and
10Mbps
Port 2)
Broadcast
DIP 2 Storm
Filter
EKI-7529MI_7529MIST_Manual_ed4
Installation
Description
On Power input 1 is active
Off Power input 1 is inactive
On Power input 2 is active
Off Power input 2 is inactive
On Power input 1 or 2 is inactive
Off Power input 1 and 2 are both active, or no power input
On Connected to 100 Mbps network
Flashing Data is transmitting or receiving
Off Not connected to 100 Mbps network
On Connected to network
Flashing Networking is active
Off Not connected to network
On Ethernet port full duplex
Flashing Collision of packets occurs
Off Ethernet port half duplex or not connect to network
Description
On 10M Full Force
Off 10M Full Auto-Negation
Broadcast Storm Filter Enable
On 3000pps@64bytes(2.02Mbps)
240pps@64bytes(0.16Mbps) for 10Mbps
Off Broadcast Storm Filter Disable
8
for 100Mbps and