Using The Combination Mode - Siemens HG193510ME Installation Instructions Manual

Table of Contents

Advertisement

Using the combination mode

Tips on using the
combination mode
Switching on combination
mode
Please note the following points when using the
combination mode:
The temperature range marked on the control
knob for the oven only applies to conventional
heating. When the combination mode is used, the
temperature in the oven is higher than the
temperature which was set on the control knob.
If you are operating the grill gas burner on the
lowest flame setting, you must also set the lowest
temperature for the oven gas burner.
1.
Open the appliance door.
2.
Switch on the grill gas burner by pressing the
control knob for the grill and turning it anti-
clockwise to position J .
The gas burner ignites.
Keep the control knob pressed for a few seconds
until the flame stabilises.
3.
Carefully close the appliance door.
4.
Open the appliance door after 10 minutes.
5.
Press the control knob for the oven, turn it anti-
clockwise to position 250 °C and hold the control
knob pressed for a few seconds until the flame has
stabilised. Then carefully close the appliance
door.
6.
Using the control knob, set the desired
temperature and heat setting for both burners.
7.
Allow the appliance to heat up for 15 minutes,
carefully open the appliance door and place the
dish inside.
59

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents