Siemens HG193510ME Installation Instructions Manual page 20

Adjusting the low flame
18
Proceed as follows:
• Open the appliance door. Press the control knob
for the oven in and turn it anti-clockwise to the
maximum setting 250.
The gas burner will light. Hold the control knob
depressed for around 15 seconds and then
release it.
• Close the appliance door. Remove the control
knob.
• Through the gas tap opening in the control panel,
loosen the internal setting screw slightly.
• Replace the control knob and heat the oven for
15 minutes.
• Then turn the control knob to the minimum setting
140.
• Remove the control knob again.
• Now, through the gas tap opening in the control
panel, adjust the internal setting screw until a
stable flame is burning correctly.
Loosen the setting screw to increase the gas flow
or tighten it to decrease the gas flow. The setting
is correct when the height of the small flame is
around 3 to 4 mm.
In the case of a connection to liquefied gas,
tighten the setting screw.
• Refit the control knob.
• Make sure that the flame does not go out when
the gas flow is changed quickly from maximum to
minimum and vice versa, and when the
appliance door is opened and closed.