Resetting The Lamp Usage Timer; Checking The Projector Status - Epson PowerLite Home Cinema 3020plus User Manual

Resetting the Lamp Usage Timer

After replacing the lamp, plug the projector back in and press the Ppower button on the
projector or the
usage timer:
1. Press the
2. Use the menu navigation buttons to open the
.
Hours
3. When you see a confirmation prompt, highlight
4. When you're finished, press the
The lamp usage timer shows 0H until you've used the lamp for at least 10 hours.

Checking the Projector Status

You can use the Info menu to view information about the current display settings and how
long the projection lamp has been in use. To access the Info menu:
1. Press the
2. Use the menu navigation buttons to open the
appears:
■
Lamp Hours
■
Source
■
Input Signal
■
Resolution
■
Scan Mode
■
Refresh Rate
Note: The information displayed depends on the currently selected image source. The Lamp
Hours shows 0H until you've used the lamp for at least 10 hours.
The resolution indicates the total number of scan lines in the source signal. The number of visible
scan lines depends on the signal format standard and selected display settings (see page 77).
64
Maintenance
button on the remote control. Then follow these steps to reset the lamp
On
button on the projector or remote control.
Menu
button on the projector or remote control.
Menu
menu, then select
Reset
Yes
button to exit.
Menu
menu. The following information
Info
■
3D Format
■
Sync Info
■
Video Signal
■
Deep Color (color depth)
■
Status (error information)
■
Serial Number
Reset Lamp
and press the button.
Enter