Solving Picture Problems - Epson PowerLite Home Cinema 3020plus User Manual

Lights indicating a problem
Light state
The temperature
light flashes red
Both warning
lights are flashing
red

Solving Picture Problems

You cannot turn on the projector.
■
Make sure the power cord is connected. Then wait a moment for the Ppower button to
light up before pressing the Ppower button on the projector or the
remote control.
■
If you've set the
use the remote control to turn on the projector (see page 37).
■
If you've set the
seconds to turn on the projector, or use the remote control (see page 37).
No picture appears on the screen or you see the
■
Press one of the
on the projector, to select the correct input source. Allow a few seconds for the projector
to sync up after pressing the button.
■
Press the
turned off temporarily.
■
Check that the power light is on and not flashing, and the lens cover is off.
■
The projector may be in standby (or sleep) mode. If the Ppower button is lit and the
power light is off, press the Ppower button to turn the projector back on.
■
Make sure your video equipment is turned on.
■
Make sure your cable(s) are connected correctly (see page 16).
68
Problem Solving
Cause and solution
There is a fan or sensor problem. Turn off the projector and
unplug it from the electrical outlet. Then contact Epson for
assistance (see page 73).
There is an internal problem. Turn off the projector and unplug it
from the electrical outlet. Then contact Epson for assistance (see
page 73).
Control Panel Lock
, you have to press the Ppower button on the projector for 3
Child Lock
buttons on the remote control, or press the
Source
button on the remote control to make sure the picture hasn't been
A/V Mute
, the control panel buttons are disabled; you must
No Signal
button on the
On
message displayed.
Source
button