Resetting the Lamp Usage Timer
After replacing the lamp, plug the projector back in, turn on the power switch on the back,
and press the P
Power
1. Press the
button on the projector or remote control.
Menu
2. Use the menu navigation buttons to open the
.
Hours
3. When you see a confirmation prompt, highlight
4. When you're finished, press the
The lamp usage timer shows 0H until you've used the lamp for at least 10 hours.
Checking the Projector Status
You can use the Info menu to view information about the current display settings and how
long the projection lamp has been in use. To access the Info menu:
1. Press the
button on the projector or remote control.
Menu
2. Use the menu navigation buttons to open the
appears:
■
Lamp Hours
■
Source
■
Input Signal
■
Resolution
■
Scan Mode
Note: The information displayed depends on the currently selected image source. The Lamp
Hours shows 0H until you've used the lamp for at least 10 hours.
The resolution indicates the total number of scan lines in the source signal. The number of visible
scan lines depends on the signal format standard and selected display settings (see page 65).
button. Then follow these steps to reset the lamp usage timer:
button to exit.
Menu
■
■
■
■
■
menu, then select
Reset
and press the
Yes
menu. The following information
Info
Refresh Rate
Sync Info
Video Signal
Deep Color (color depth)
Status (error information)
Reset Lamp
button.
Enter
Maintenance
53