The Image Is Truncated (Large) Or Small, The Aspect Is Not Suitable, Or The Image Has Been Reversed; Image Colors Are Not Right - Epson EB-1965 User Manual

Problem Solving

The image is truncated (large) or small, the aspect is not suitable, or the image has been reversed

Check
Is a wide panel computer image being projected?
(Only when projecting computer images)
Is the image still being enlarged by E-Zoom?
Is the image position adjusted correctly?
Is the computer set for dual display?
(Only when projecting computer images)
Is the correct resolution selected?
(Only when projecting computer images)
Is the projection mode correct?

Image colors are not right

Check
Do the input signal settings match the signals from the connected
device?
Is the image brightness adjusted correctly?
Change the setting according to the signal for the connected equipment.
s Signal - Resolution p.92
Press the [Esc] button on the remote control to cancel E-Zoom.
s "Enlarging Part of the Image (E-Zoom)"
(Only when projecting analog RGB signals input from the Computer port)
Press the [Auto] button on the remote control or the [
You can also adjust the position from the Configuration menu.
s Signal - Position p.92
If dual display is activated in the Display Properties of the computer's Control Panel, only about half of the image on the
computer screen is projected. To display the entire image on the computer screen, turn off the dual display setting.
s Computer video driver documentation
Set the computer so that the signals being output are compatible with the projector.
s "Supported Monitor Displays" p.144
s Computer's documentation
Depending on how the projector is installed, set the projection mode from one of the following: Front, Front/Ceiling,
Rear, or Rear/Ceiling.
s Extended - Projection p.95
s "Installation Methods" p.22
Change the following settings according to the signal for the connected equipment.
• When the image is from a device connected to the Computer port
s Signal - Input Signal p.92
• When the image is from a device connected to the Video port
s Signal - Video Signal p.92
Adjust the Brightness setting from the Configuration menu.
s Image - Brightness p.91
Remedy
p.60
] button on the control panel to adjust the position.
Remedy
121