Correcting - Epson EB-1965 User Manual

Projection Functions
Selecting the ID for the projector you want to operate using the remote control
a
Select the ID each time you turn on the projector. When the projector
is turned on, the ID set for the remote control is 0.
a
Point the remote control at the remote receiver of the target
projector and press the [ID] button on the remote control.
When you press the [ID] button, the current Projector ID is
displayed on the projection screen. It disappears in about three
seconds.
Remote control
b
While holding the [ID] button, press the number button that
matches the ID of the projector you want to operate.
The projector you want to operate is selected.

Correcting

After setting up the projectors, correct the brightness and tone for each
projector to reduce the differences.
a
Press the [Menu] button.
"Using the Configuration Menu"
s
b
Select Multi-screen from Extended.
c
Select the level to be corrected in Adjustment Level.
• Each time a level is selected, the pattern of the level selected is
displayed.
• You can start correcting from any level, usually you can make it
darker or lighter by correcting 1 to 5 or 5 to 1.
d
Correct the brightness with Brightness Correct.
64
p.88