Epson EB-1965 User Manual page 96

List of Functions
Submenu
Projection Select from one of the following projection methods
depending on how the projector is installed.
Front, Front/Ceiling, Rear, and Rear/Ceiling
You can change the setting as follows by pressing down
the [A/V Mute] button on the remote control for about five
seconds.
FrontWFront/Ceiling
RearWRear/Ceiling
s "Installation Methods"
Direct Power On: Set to On to turn on the projector
Operation
simply by plugging it in.
When the power cord is plugged in, note that the projector
turns on automatically in cases such as a power outage
being restored.
Sleep Mode: When set to On, this automatically stops
projection when no image signal is being input and no
operations are carried out.
Sleep Mode Timer: When Sleep Mode is set to On, you
can set the time before the projector automatically turns off
within a range of 1 to 30 minutes.
Lens Cover Timer: When set to On, this turns off the
power automatically 30 minutes after the A/V mute slide is
closed.
The default value is On.
High Altitude Mode: Set to On when using the projector
above an altitude of 1500 m.
Audio Input: When set to Auto, the audio from the input
source is output.
When set to Audio1, Audio2, or Audio (L/R), audio is
output from the selected port regardless of the input source
as long as audio is input from the audio input port.
Function
p.22
Submenu
Standby Mode If you set Communication On, you can perform the
following operations even if the projector is in standby
mode.
• Monitoring and controlling the projector over a network
s "Monitoring and Controlling"
• Outputting analog RGB signals from the Computer1 port
to an external monitor
Set the ID to a number between 1 and 9. Off indicates that
Projector ID
no ID is set.
s "Setting the projector ID"
You can adjust the hue and brightness of each projected
Multi-screen
image when multiple projectors are lined up and projecting.
Adjustment Level: You can adjust from black to white in
five stages called Level 1 to 5, and in each of these 5 levels,
you can adjust Brightness Correct. and Color Correct.
Brightness Correct.: You can correct the difference in the
brightness of each projector.
Color Correct. (G/R) / Color Correct. (B/Y): You can
correct the difference in the color of each projector.
s "Correcting the Color Difference when Projecting from
Multiple Projectors"
Time/Schedule You can set the projector's date and time, and the
projector's schedule so that it performs a specific operation
Settings
at a pre-scheduled time.
s "Setting Schedule"
Language You can set the language for messages and menus.
Function
p.74
p.63
p.62
p.85
96